P08C7 — Pressure control solenoid M: intermittent fault
| Meaning | The transmission control unit detected a problem on pressure solenoid "M" that shows up at times and then goes away. It is often a contact that breaks with vibration, heat or moisture. The letter "M" is generic and the solenoid changes between manufacturers, so I cannot tell you for certain which one it is on your car. |
| Family | Powertrain (P) |
Typical symptoms
Shifts sometimes harsh and sometimes normal
Gearbox going into limp mode and then returning to normal
Problem appearing more when hot or on rough roads
Occasional slipping
Common causes
Chafed wire touching intermittently
Solenoid with a coil that fails when it heats up
Moisture or oil in the connector
Transmission control unit with an occasional problem (rare)
What to do
How to read code P08C7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P08C7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (C7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P08C7 mean?
Pressure control solenoid M: intermittent fault. The transmission control unit detected a problem on pressure solenoid "M" that shows up at times and then goes away. It is often a contact that breaks with vibration, heat or moisture. The letter "M" is generic and the solenoid changes between manufacturers, so I cannot tell you for certain which one it is on your car.
Can I keep driving with code P08C7 active?
With caution: limp mode possible, have it checked soon
Common causes — P08C7
Connector with an unstable contact Chafed wire touching intermittently Solenoid with a coil that fails when it heats up Moisture or oil in the connector Transmission control unit with an occasional problem (rare)
How do you fix code P08C7?
Look for the point that breaks by carefully moving the wiring and connectors while reading the diagnosis. Even if the fault goes away, do not ignore it: it can come back while you are driving.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P08C6 — Pressure control solenoid M: electrical fault
- Next code: P08C8 — Pressure control solenoid M: control circuit open
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault