P08C8 — Pressure control solenoid M: control circuit open
| Meaning | The transmission control unit detected that the control circuit of pressure solenoid "M" is broken: the command is sent but there is no electrical continuity. The letter "M" is generic and depends on the manufacturer, so I cannot tell you for certain which solenoid it is on your car. |
| Family | Powertrain (P) |
Typical symptoms
Gearbox in limp mode
Harsh or delayed shifts
Gears not engaging
Slipping in some conditions
Common causes
Broken wire in the harness
Solenoid with an open coil
Damaged internal gearbox wiring
Faulty transmission control unit (rare)
What to do
How to read code P08C8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P08C8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (C8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P08C8 mean?
Pressure control solenoid M: control circuit open. The transmission control unit detected that the control circuit of pressure solenoid "M" is broken: the command is sent but there is no electrical continuity. The letter "M" is generic and depends on the manufacturer, so I cannot tell you for certain which solenoid it is on your car.
Can I keep driving with code P08C8 active?
With caution: limp mode possible, have it checked soon
Common causes — P08C8
Oxidized or poorly seated connector Broken wire in the harness Solenoid with an open coil Damaged internal gearbox wiring Faulty transmission control unit (rare)
How do you fix code P08C8?
Check the gearbox connectors and wiring, then measure the solenoid resistance. If the gearbox is in limp mode, do not force it and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P08C7 — Pressure control solenoid M: intermittent fault
- Next code: P08C9 — Pressure control solenoid M: control circuit range...
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault