Skip to content
Fault code dictionary (DTC)

P08DA — Shift solenoid K: control circuit out of range

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit sees a signal in the control circuit of shift solenoid K that is present but outside the expected values, for example abnormal current or resistance. The circuit is not fully open, but something is altering it. The role of valve K depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Imprecise or delayed shifts
Jerks when changing gear
Gearbox in limp mode
Engine or transmission warning light on
Slipping in some gears

Common causes

Connector with oxidised contacts or abnormal resistance
Damaged wiring or partial short to ground
Solenoid with an altered coil
Unstable supply voltage (battery or ground)
Faulty transmission control unit

What to do

First check the battery, grounds and connectors, because unstable voltage can distort the readings. Then electrical measurements on the valve circuit are needed. If the gearbox misbehaves, limit use of the car.

How to read code P08DA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P08DA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (DA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P08DA mean?

Shift solenoid K: control circuit out of range. The control unit sees a signal in the control circuit of shift solenoid K that is present but outside the expected values, for example abnormal current or resistance. The circuit is not fully open, but something is altering it. The role of valve K depends on the manufacturer.

Can I keep driving with code P08DA active?

With caution: limp mode possible, have it checked soon

Common causes — P08DA

Connector with oxidised contacts or abnormal resistance Damaged wiring or partial short to ground Solenoid with an altered coil Unstable supply voltage (battery or ground) Faulty transmission control unit

How do you fix code P08DA?

First check the battery, grounds and connectors, because unstable voltage can distort the readings. Then electrical measurements on the valve circuit are needed. If the gearbox misbehaves, limit use of the car.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes