Skip to content
Fault code dictionary (DTC)

P08DB — Shift solenoid K: low voltage in control circuit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe transmission control unit measured too low a voltage in the circuit that drives shift solenoid K. It often means a short to ground or an abnormal resistance in the circuit. The role of valve K depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Delayed or harsh shifts
Gearbox in limp mode
Engine or transmission warning light on
Gear that will not engage
Slipping in some gears

Common causes

Control wire touching ground
Chafed wiring or a connector with water in it
Solenoid with a shorted winding
Insufficient supply or a bad ground
Faulty transmission control unit

What to do

Check the battery and grounds, then the gearbox wiring and connector, looking for chafing or moisture. The location of the short is found with electrical measurements. If the gearbox is in limp mode, cut down on driving.

How to read code P08DB

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P08DB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (DB) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P08DB mean?

Shift solenoid K: low voltage in control circuit. The transmission control unit measured too low a voltage in the circuit that drives shift solenoid K. It often means a short to ground or an abnormal resistance in the circuit. The role of valve K depends on the manufacturer.

Can I keep driving with code P08DB active?

With caution: limp mode possible, have it checked soon

Common causes — P08DB

Control wire touching ground Chafed wiring or a connector with water in it Solenoid with a shorted winding Insufficient supply or a bad ground Faulty transmission control unit

How do you fix code P08DB?

Check the battery and grounds, then the gearbox wiring and connector, looking for chafing or moisture. The location of the short is found with electrical measurements. If the gearbox is in limp mode, cut down on driving.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes