P08DC — Shift solenoid K: high voltage in control circuit
| Meaning | The transmission control unit measured too high a voltage in the circuit that drives shift solenoid K. The signal is not what is expected, often because of a short to a power supply or a faulty electrical part. The role of valve K depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Delay when engaging a gear
Gearbox in limp mode
Engine or transmission warning light on
Slipping in some gears
Common causes
Solenoid with a faulty winding
Control wire touching a power supply
Transmission control unit with a faulty driver
Moisture or oil in the connector
What to do
How to read code P08DC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P08DC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (DC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P08DC mean?
Shift solenoid K: high voltage in control circuit. The transmission control unit measured too high a voltage in the circuit that drives shift solenoid K. The signal is not what is expected, often because of a short to a power supply or a faulty electrical part. The role of valve K depends on the manufacturer.
Can I keep driving with code P08DC active?
With caution: limp mode possible, have it checked soon
Common causes — P08DC
Damaged or corroded wiring or connector Solenoid with a faulty winding Control wire touching a power supply Transmission control unit with a faulty driver Moisture or oil in the connector
How do you fix code P08DC?
Check the gearbox fluid level and condition, then the connectors and wiring. If the gearbox jerks or goes into limp mode, reduce use of the car. To tell wiring, valve and control unit apart, a scan tool diagnosis is needed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P08DB — Shift solenoid K: low voltage in control circuit
- Next code: P08DD — Shift solenoid K: control circuit open
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault