P0B38 — Motor electronics coolant pump B control circuit open
| Meaning | The control unit detected a problem or an open circuit in the control of coolant pump B for the electric motor electronics (inverter and similar parts). Which pump counts as B in the system is set by the manufacturer. Without cooling the electronics can overheat, so power may be reduced. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power
System overheating message
Cooling fans running very hard
System shutting down in heat or under heavy load
Common causes
Seized or failed coolant pump
Fuse or relay feeding the pump
Low coolant level or air in the cooling circuit
Fault in the control unit that drives the pump
What to do
How to read code P0B38
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B38 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (38) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B38 mean?
Motor electronics coolant pump B control circuit open. The control unit detected a problem or an open circuit in the control of coolant pump B for the electric motor electronics (inverter and similar parts). Which pump counts as B in the system is set by the manufacturer. Without cooling the electronics can overheat, so power may be reduced.
Can I keep driving with code P0B38 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B38
Broken pump wiring or connector Seized or failed coolant pump Fuse or relay feeding the pump Low coolant level or air in the cooling circuit Fault in the control unit that drives the pump
How do you fix code P0B38?
Watch for high temperature warnings and do not push the car if it overheats. First check the supply, connector and operation of the pump, plus the electronics coolant level. Do not delay, because overheating can damage expensive parts.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B37 — High-voltage service disconnect open
- Next code: P0B39 — Motor electronics coolant pump B control circuit l...
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high