P0B47 — HV battery voltage sensor C: signal too low
| Meaning | The control unit found that the signal from traction battery voltage sensor C is lower than the expected minimum. This usually means an open circuit, a short to ground, or a sensor that does not respond. What letter C refers to exactly depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Limited power or limp mode
Battery charge reading wrong or missing
Charging blocked or interrupted
Car struggling to get going
Common causes
Corroded or loose connector, or bent terminals
Faulty sensor or cell monitoring board
Missing reference supply to the sensor
Battery management unit fault
What to do
How to read code P0B47
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B47 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (47) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B47 mean?
HV battery voltage sensor C: signal too low. The control unit found that the signal from traction battery voltage sensor C is lower than the expected minimum. This usually means an open circuit, a short to ground, or a sensor that does not respond. What letter C refers to exactly depends on the manufacturer.
Can I keep driving with code P0B47 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B47
Measuring-circuit wire broken or shorted to ground Corroded or loose connector, or bent terminals Faulty sensor or cell monitoring board Missing reference supply to the sensor Battery management unit fault
How do you fix code P0B47?
Do not work on the battery pack or the orange cables: this is a high-voltage system and needs qualified personnel. Have it checked urgently, as the car may limit power or stop.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B46 — HV battery voltage sensor C: signal out of range
- Next code: P0B48 — HV battery voltage sensor C: signal too high
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high