Skip to content
Fault code dictionary (DTC)

P0B48 — HV battery voltage sensor C: signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit read a value from traction battery voltage sensor C that is above the expected maximum. It can come from a short to a supply, a poor contact, or a sensor that measures wrongly. Letter C is a manufacturer designation.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on
Reduced power
Inconsistent charge indicator
Limited or interrupted charging
Power system fault message

Common causes

Measuring wire shorted to a supply
Wet, corroded or damaged connector
Faulty sensor or cell monitoring board
Real cell group voltage out of limits
Battery management unit fault

What to do

Do not touch anything in the high-voltage system: diagnosis must be done by qualified personnel. If the high reading were real it could be a serious battery issue, so have the car checked soon and do not ignore the light.

How to read code P0B48

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0B48 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (48) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0B48 mean?

HV battery voltage sensor C: signal too high. The control unit read a value from traction battery voltage sensor C that is above the expected maximum. It can come from a short to a supply, a poor contact, or a sensor that measures wrongly. Letter C is a manufacturer designation.

Can I keep driving with code P0B48 active?

With caution: limp mode possible, have it checked soon

Common causes — P0B48

Measuring wire shorted to a supply Wet, corroded or damaged connector Faulty sensor or cell monitoring board Real cell group voltage out of limits Battery management unit fault

How do you fix code P0B48?

Do not touch anything in the high-voltage system: diagnosis must be done by qualified personnel. If the high reading were real it could be a serious battery issue, so have the car checked soon and do not ignore the light.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes