Skip to content
Fault code dictionary (DTC)

P0B49 — HV battery voltage sensor C: intermittent signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit is getting a signal from traction battery voltage sensor C that drops out or jumps irregularly. It is usually a contact that is lost with vibration or temperature changes. The fault may come and go, but the cause is still there.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV warning light coming on at times
Occasional loss of power
Charge indicator wavering
Charging that starts and stops
More frequent problems on rough roads

Common causes

Loose connector or worn terminals
Wiring with damaged insulation or a partly broken wire
Moisture or corrosion in the contacts
Sensor or cell monitoring board with an intermittent defect
Intermittent battery management unit fault

What to do

Do not wait on an intermittent fault: sooner or later it becomes permanent. Do not open the high-voltage system; have connectors and wiring checked by qualified personnel soon.

How to read code P0B49

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0B49 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (49) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0B49 mean?

HV battery voltage sensor C: intermittent signal. The control unit is getting a signal from traction battery voltage sensor C that drops out or jumps irregularly. It is usually a contact that is lost with vibration or temperature changes. The fault may come and go, but the cause is still there.

Can I keep driving with code P0B49 active?

With caution: limp mode possible, have it checked soon

Common causes — P0B49

Loose connector or worn terminals Wiring with damaged insulation or a partly broken wire Moisture or corrosion in the contacts Sensor or cell monitoring board with an intermittent defect Intermittent battery management unit fault

How do you fix code P0B49?

Do not wait on an intermittent fault: sooner or later it becomes permanent. Do not open the high-voltage system; have connectors and wiring checked by qualified personnel soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes