P0C1E — Auxiliary transmission pump module temperature sensor low signal
| Meaning | The control unit detected a signal that is too low from the temperature sensor inside the electric transmission fluid pump module. It may indicate a short to ground in the sensor circuit or a failure of the sensor itself, and the temperature reading cannot be trusted. |
| Family | Powertrain (P) |
Typical symptoms
Start-stop or electric driving limited
Gearbox with delayed reactions
Pump running unevenly
No obvious symptom in mild cases
Common causes
Short to ground in the sensor circuit
Faulty control module
Wet or damaged connector
Crushed or worn wiring
What to do
How to read code P0C1E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C1E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (1E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C1E mean?
Auxiliary transmission pump module temperature sensor low signal. The control unit detected a signal that is too low from the temperature sensor inside the electric transmission fluid pump module. It may indicate a short to ground in the sensor circuit or a failure of the sensor itself, and the temperature reading cannot be trusted.
Can I keep driving with code P0C1E active?
With caution: limp mode possible, have it checked soon
Common causes — P0C1E
Failed sensor inside the module Short to ground in the sensor circuit Faulty control module Wet or damaged connector Crushed or worn wiring
How do you fix code P0C1E?
Have the module connector and wiring checked at a workshop, then the module itself. If the sensor is internal, the pump or module may need replacing. It's not among the most urgent faults, but it's best to act soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C1D — Auxiliary transmission pump module temperature imp...
- Next code: P0C1F — Auxiliary transmission pump module temperature sen...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open