P0C1F — Auxiliary transmission pump module temperature sensor high signal
| Meaning | The control unit detected a signal that is too high from the temperature sensor inside the electric transmission fluid pump module. It may indicate an open circuit or a sensor failure, and the temperature reading cannot be trusted. |
| Family | Powertrain (P) |
Typical symptoms
Start-stop or electric driving limited
Gearbox with delayed reactions
Pump running unevenly
No obvious symptom in mild cases
Common causes
Open or poor-contact sensor circuit
Faulty control module
Corroded or loose connector
Damaged wiring
What to do
How to read code P0C1F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C1F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (1F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C1F mean?
Auxiliary transmission pump module temperature sensor high signal. The control unit detected a signal that is too high from the temperature sensor inside the electric transmission fluid pump module. It may indicate an open circuit or a sensor failure, and the temperature reading cannot be trusted.
Can I keep driving with code P0C1F active?
With caution: limp mode possible, have it checked soon
Common causes — P0C1F
Failed sensor inside the module Open or poor-contact sensor circuit Faulty control module Corroded or loose connector Damaged wiring
How do you fix code P0C1F?
Have the module connector and wiring checked, then the module at a workshop. The sensor often can't be replaced on its own. It's best to act soon, because without a correct reading the module can't protect itself from heat.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C1E — Auxiliary transmission pump module temperature sen...
- Next code: P0C20 — Auxiliary transmission pump phases U-V-W open circ...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open