P0C22 — Auxiliary transmission fluid pump motor phase U-V-W circuit high
| Meaning | The control unit detected a voltage that is too high on one or more of the three wires (phases U, V, W) that power the electric motor of the auxiliary transmission fluid pump. This pump keeps pressure in the transmission when the combustion engine is off, for example on hybrids or with Stop&Start. If the circuit is faulty, the pump may not run as intended. |
| Family | Powertrain (P) |
Typical symptoms
Delayed or harsh gear engagement after a restart
Transmission going into a limited-performance fail-safe mode
Stop&Start or electric driving disabled
Unusual hum or noise from the transmission area
Common causes
Pump connector corroded, loose or with bent terminals
Pump motor windings failing
Faulty pump drive electronics
Wiring crushed or chafed near the transmission
What to do
How to read code P0C22
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C22 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (22) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C22 mean?
Auxiliary transmission fluid pump motor phase U-V-W circuit high. The control unit detected a voltage that is too high on one or more of the three wires (phases U, V, W) that power the electric motor of the auxiliary transmission fluid pump. This pump keeps pressure in the transmission when the combustion engine is off, for example on hybrids or with Stop&Start. If the circuit is faulty, the pump may not run as intended.
Can I keep driving with code P0C22 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C22
Damaged phase wire or a wire touching an outside voltage Pump connector corroded, loose or with bent terminals Pump motor windings failing Faulty pump drive electronics Wiring crushed or chafed near the transmission
How do you fix code P0C22?
Have the pump wiring and connector inspected soon, because a long-lasting fault can leave the transmission poorly lubricated. On hybrid or electric cars the orange cables are high voltage: do not touch them, leave the work to a qualified technician. Avoid long trips until the cause is found.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C21 — Auxiliary transmission pump phases U-V-W low circu...
- Next code: P0C23 — Auxiliary transmission pump control module circuit...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open