P0C25 — Auxiliary transmission pump control module circuit high
| Meaning | The control unit detects a voltage that is too high in the circuit of the control module of the electric auxiliary transmission fluid pump. It often means a wire is touching a power supply where it should not, or that the module has failed. The pump may not be driven correctly. |
| Family | Powertrain (P) |
Typical symptoms
Irregular gear engagement
Stop&Start or electric driving unavailable
Fail-safe mode with limited power
Transmission fault message
Common causes
Wet or corroded connector
Faulty pump control module
Electrical system voltage problem
Wiring damaged near the transmission
What to do
How to read code P0C25
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C25 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (25) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C25 mean?
Auxiliary transmission pump control module circuit high. The control unit detects a voltage that is too high in the circuit of the control module of the electric auxiliary transmission fluid pump. It often means a wire is touching a power supply where it should not, or that the module has failed. The pump may not be driven correctly.
Can I keep driving with code P0C25 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C25
Wire touching a power supply because of damaged insulation Wet or corroded connector Faulty pump control module Electrical system voltage problem Wiring damaged near the transmission
How do you fix code P0C25?
Have the wiring and connector of the pump module inspected, looking for rubbing or moisture. Abnormal voltage can damage other electronics, so do not leave it for long. If the transmission is irregular, reduce use of the car.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C24 — Auxiliary transmission pump control module circuit...
- Next code: P0C26 — Auxiliary transmission fluid pump A motor current...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open