Skip to content
Fault code dictionary (DTC)

P0C26 — Auxiliary transmission fluid pump A motor current fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the current drawn by the motor of the auxiliary transmission fluid pump is not what it expects. Current shows how hard the pump is working, so a wrong value can point to mechanical wear or an electrical problem. This code does not say whether the current is too high or too low; the neighbouring codes cover that.
FamilyPowertrain (P)

Typical symptoms

Check engine or transmission warning light on
Delayed gear engagement
Stop&Start disabled
Noisy or humming pump
Fail-safe mode with reduced performance

Common causes

Pump with worn bearings or internal friction
Dirty, degraded or wrong type of transmission fluid
Wiring or connector with abnormal resistance
Faulty pump control module
Damaged pump electric motor

What to do

Have the transmission fluid level and condition checked, along with the pump wiring. With abnormal current the pump can overheat or stop, so it is best to act soon. If the transmission is irregular, avoid long trips.

How to read code P0C26

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0C26 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (26) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0C26 mean?

Auxiliary transmission fluid pump A motor current fault. The control unit detected that the current drawn by the motor of the auxiliary transmission fluid pump is not what it expects. Current shows how hard the pump is working, so a wrong value can point to mechanical wear or an electrical problem. This code does not say whether the current is too high or too low; the neighbouring codes cover that.

Can I keep driving with code P0C26 active?

With caution: limp mode possible, have it checked soon

Common causes — P0C26

Pump with worn bearings or internal friction Dirty, degraded or wrong type of transmission fluid Wiring or connector with abnormal resistance Faulty pump control module Damaged pump electric motor

How do you fix code P0C26?

Have the transmission fluid level and condition checked, along with the pump wiring. With abnormal current the pump can overheat or stop, so it is best to act soon. If the transmission is irregular, avoid long trips.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes