P0C28 — Auxiliary transmission fluid pump A motor current high
| Meaning | The current drawn by the motor of the auxiliary transmission fluid pump is higher than expected. It usually means the pump is working too hard because of internal friction, thick fluid or partial seizure, or that there is a short in the circuit. Prolonged high current can overheat the pump and its module. |
| Family | Powertrain (P) |
Typical symptoms
Loud noisy or humming pump
Irregular gear engagement
Stop&Start disabled
Fail-safe mode with reduced performance
Common causes
Degraded, dirty or overly thick transmission fluid
Partial short in the wiring or motor
Faulty pump control module
Debris obstructing the pump
What to do
How to read code P0C28
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C28 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (28) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C28 mean?
Auxiliary transmission fluid pump A motor current high. The current drawn by the motor of the auxiliary transmission fluid pump is higher than expected. It usually means the pump is working too hard because of internal friction, thick fluid or partial seizure, or that there is a short in the circuit. Prolonged high current can overheat the pump and its module.
Can I keep driving with code P0C28 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C28
Pump with seized or worn bearings Degraded, dirty or overly thick transmission fluid Partial short in the wiring or motor Faulty pump control module Debris obstructing the pump
How do you fix code P0C28?
Have the transmission fluid and the pump condition checked soon: high current can damage the electronics. If you hear unusual noises or the car goes into a reduced mode, avoid driving it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C27 — Auxiliary transmission fluid pump A motor current...
- Next code: P0C29 — Auxiliary transmission fluid pump A driver circuit...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open