P0C2A — Auxiliary transmission fluid pump A motor stalled
| Meaning | The control unit believes the motor of the auxiliary transmission fluid pump is stuck or cannot turn when it should. The rotor may be seized, or the pump may be hindered by dirt or overly thick fluid. Without this pump, the transmission may lack the pressure it needs while the combustion engine is stopped. |
| Family | Powertrain (P) |
Typical symptoms
Gears not engaging or engaging poorly after a restart
Hum from the pump without it turning
Stop&Start or electric driving disabled
Transmission fail-safe mode
Common causes
Debris in the fluid blocking the pump
Transmission fluid too thick or degraded
Burnt-out electric motor
Faulty control module or power supply
What to do
How to read code P0C2A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C2A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (2A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C2A mean?
Auxiliary transmission fluid pump A motor stalled. The control unit believes the motor of the auxiliary transmission fluid pump is stuck or cannot turn when it should. The rotor may be seized, or the pump may be hindered by dirt or overly thick fluid. Without this pump, the transmission may lack the pressure it needs while the combustion engine is stopped.
Can I keep driving with code P0C2A active?
With caution: limp mode possible, have it checked soon
Common causes — P0C2A
Pump seized through wear or bearings Debris in the fluid blocking the pump Transmission fluid too thick or degraded Burnt-out electric motor Faulty control module or power supply
How do you fix code P0C2A?
This is a fault to take seriously: have the pump and the transmission fluid checked as soon as possible. Continuing to drive with a stalled pump can damage the transmission. If the car is in fail-safe mode, avoid using it unless necessary.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C29 — Auxiliary transmission fluid pump A driver circuit...
- Next code: P0C2B — Auxiliary transmission pump control module feedbac...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open