P0C2B — Auxiliary transmission pump control module feedback signal fault
| Meaning | The control unit receives a feedback signal from the control module of the auxiliary transmission fluid pump that is not correct. This signal confirms that the pump is doing what it was asked to do. If it is wrong, the control unit cannot trust the real state of the pump. |
| Family | Powertrain (P) |
Typical symptoms
Irregular gear engagement
Stop&Start disabled
Intermittent transmission behaviour
Possible fail-safe mode
Common causes
Corroded connector
Faulty pump control module
Pump not carrying out the command
Interference or problems on the communication line
What to do
How to read code P0C2B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C2B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (2B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C2B mean?
Auxiliary transmission pump control module feedback signal fault. The control unit receives a feedback signal from the control module of the auxiliary transmission fluid pump that is not correct. This signal confirms that the pump is doing what it was asked to do. If it is wrong, the control unit cannot trust the real state of the pump.
Can I keep driving with code P0C2B active?
With caution: limp mode possible, have it checked soon
Common causes — P0C2B
Signal wire damaged or with weak contact Corroded connector Faulty pump control module Pump not carrying out the command Interference or problems on the communication line
How do you fix code P0C2B?
Have the wiring and connector of the pump module checked and, with a diagnostic tool, verify whether the pump responds to commands. Do not leave the problem for long, because the control unit may limit the transmission.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C2A — Auxiliary transmission fluid pump A motor stalled
- Next code: P0C2C — Auxiliary transmission pump module feedback signal...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open