P0C2C — Auxiliary transmission pump module feedback signal out of range
| Meaning | The feedback signal that the control module of the auxiliary transmission fluid pump sends to the control unit is present, but it is not consistent with what is expected: it is out of limits or does not follow the expected pattern. The circuit is therefore not necessarily broken, but the data cannot be trusted. It can point to a problem in the module, the wiring or the pump itself. |
| Family | Powertrain (P) |
Typical symptoms
Slow or jerky gear engagement
Intermittent Stop&Start
Changes in pump noise
Occasional fail-safe mode
Common causes
Control module working unstably
Pump not reaching the requested speed
Wiring with abnormal resistance
Unstable power supply
What to do
How to read code P0C2C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C2C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (2C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C2C mean?
Auxiliary transmission pump module feedback signal out of range. The feedback signal that the control module of the auxiliary transmission fluid pump sends to the control unit is present, but it is not consistent with what is expected: it is out of limits or does not follow the expected pattern. The circuit is therefore not necessarily broken, but the data cannot be trusted. It can point to a problem in the module, the wiring or the pump itself.
Can I keep driving with code P0C2C active?
With caution: limp mode possible, have it checked soon
Common causes — P0C2C
Dirty or loose connector contacts Control module working unstably Pump not reaching the requested speed Wiring with abnormal resistance Unstable power supply
How do you fix code P0C2C?
Have the power supply, connectors and wiring checked, then the pump and module operation. If the fault is intermittent, tell the technician under what conditions it appears. Act within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C2B — Auxiliary transmission pump control module feedbac...
- Next code: P0C2D — Auxiliary transmission pump module feedback signal...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open