P0C4C — Battery coolant pump A: supply voltage too low
| Meaning | The control unit measures a lower-than-expected voltage at pump A, which circulates coolant for the battery. The pump may run slowly or unsteadily and cool the high-voltage battery poorly. The exact threshold depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power under load
Pump running slowly or erratically
Battery temperature higher than normal
Slower charging
Common causes
Damaged wiring or a short to ground
Weak or discharged 12 V battery
Fuse or relay with worn contacts
Pump drawing too much current due to an internal fault
What to do
How to read code P0C4C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C4C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (4C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C4C mean?
Battery coolant pump A: supply voltage too low. The control unit measures a lower-than-expected voltage at pump A, which circulates coolant for the battery. The pump may run slowly or unsteadily and cool the high-voltage battery poorly. The exact threshold depends on the manufacturer.
Can I keep driving with code P0C4C active?
With caution: limp mode possible, have it checked soon
Common causes — P0C4C
Corroded or high-resistance pump connector or ground Damaged wiring or a short to ground Weak or discharged 12 V battery Fuse or relay with worn contacts Pump drawing too much current due to an internal fault
How do you fix code P0C4C?
Check the condition of the 12 V battery and the ground and connector of the pump first, since low voltage often starts there. Limit heavy loads and fast charging. Have the system checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C4B — Battery coolant pump A: supply voltage circuit ope...
- Next code: P0C4D — Battery coolant pump A: supply voltage too high
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open