Skip to content
Fault code dictionary (DTC)

P0C78 — High-voltage system precharge time too long

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningDuring precharge the capacitors in the power circuits must reach battery voltage within a set time. The control unit found it took longer than expected. Often something is drawing current or leaking, or a precharge component is not working properly.
FamilyPowertrain (P)

Typical symptoms

Hybrid/EV fault light on
Slow starting or car not going into ready mode
Hybrid system check message
Limp mode
Car shutting down right after starting

Common causes

Faulty precharge resistor or relay
Leak or short to ground on the power circuit
Faulty capacitor or inverter
Low battery voltage or unbalanced cells
Loose or corroded high-voltage connections

What to do

Avoid repeating many start attempts and have the car checked by a workshop qualified for high voltage. Do not touch the orange cables. If the car will not start, it is better to have it transported.

How to read code P0C78

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0C78 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (78) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0C78 mean?

High-voltage system precharge time too long. During precharge the capacitors in the power circuits must reach battery voltage within a set time. The control unit found it took longer than expected. Often something is drawing current or leaking, or a precharge component is not working properly.

Can I keep driving with code P0C78 active?

With caution: limp mode possible, have it checked soon

Common causes — P0C78

Faulty precharge resistor or relay Leak or short to ground on the power circuit Faulty capacitor or inverter Low battery voltage or unbalanced cells Loose or corroded high-voltage connections

How do you fix code P0C78?

Avoid repeating many start attempts and have the car checked by a workshop qualified for high voltage. Do not touch the orange cables. If the car will not start, it is better to have it transported.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes