P0CC3 — Drive motor coolant pump A: control circuit low
| Meaning | The control unit measured a voltage that is too low on the circuit commanding the drive motor coolant pump A. This usually points to a short to ground, a damaged wire, or a driver that cannot operate the pump. In this condition the pump may not run and the electric motor is not cooled properly. |
| Family | Powertrain (P) |
Typical symptoms
Limited power when accelerating
High electric motor temperature warning
Coolant pump silent or not running
Possible reduced performance during extended driving
Common causes
Damp or corroded pump connector
Pump with internally shorted winding
Fuse or pump power supply problem
Faulty control module
What to do
How to read code P0CC3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0CC3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (C3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0CC3 mean?
Drive motor coolant pump A: control circuit low. The control unit measured a voltage that is too low on the circuit commanding the drive motor coolant pump A. This usually points to a short to ground, a damaged wire, or a driver that cannot operate the pump. In this condition the pump may not run and the electric motor is not cooled properly.
Can I keep driving with code P0CC3 active?
With caution: limp mode possible, have it checked soon
Common causes — P0CC3
Pump control wire pinched or shorted to ground Damp or corroded pump connector Pump with internally shorted winding Fuse or pump power supply problem Faulty control module
How do you fix code P0CC3?
Check the fuses and the pump connector, and look for chafed wires or signs of moisture along the harness. If the pump is not running the motor can overheat, so limit use of the car and have an electrical check done as soon as possible.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0CC2 — Drive motor coolant pump A: control circuit range/...
- Next code: P0CC4 — Drive motor coolant pump A: control circuit high
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open