Skip to content
Fault code dictionary (DTC)

P00AC — Intake air temperature sensor 1 signal low (bank 2)

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the signal from the first intake air temperature sensor on bank 2 is below the expected limit. The voltage is too low, as if the air were very hot or as if the wire were shorted to ground. It is usually an electrical problem in the circuit or in the sensor.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Unstable idle
Hard or slow cold starts
Loss of power
Higher than normal fuel consumption

Common causes

Signal wire shorted to ground
Wet or damaged connector
Faulty sensor with an internal short
Crushed or chafed wiring
Engine control unit fault (rare)

What to do

First check the connector and the wiring reaching the bank 2 sensor, looking for chafed wires or moisture. The car often still moves, but the engine may be running on fallback values, so have it checked soon.

How to read code P00AC

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00AC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (AC) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00AC mean?

Intake air temperature sensor 1 signal low (bank 2). The control unit detected that the signal from the first intake air temperature sensor on bank 2 is below the expected limit. The voltage is too low, as if the air were very hot or as if the wire were shorted to ground. It is usually an electrical problem in the circuit or in the sensor.

Can I keep driving with code P00AC active?

With caution: limp mode possible, have it checked soon

Common causes — P00AC

Signal wire shorted to ground Wet or damaged connector Faulty sensor with an internal short Crushed or chafed wiring Engine control unit fault (rare)

How do you fix code P00AC?

First check the connector and the wiring reaching the bank 2 sensor, looking for chafed wires or moisture. The car often still moves, but the engine may be running on fallback values, so have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes