P00AD — Intake air temperature sensor 1 signal high (bank 2)
| Meaning | The control unit detected that the signal from the first intake air temperature sensor on bank 2 is above the expected limit. The voltage is too high, as if the air were freezing or as if the circuit were open. It usually points to a detached wire, an open connector or a faulty sensor. |
| Family | Powertrain (P) |
Typical symptoms
Hard cold starts
Rough idle
Loss of power
Dark smoke or higher consumption when cold
Common causes
Broken signal or ground wire
Faulty sensor with an open circuit
Corrosion in the connector
Cut or torn wiring
Engine control unit fault (rare)
What to do
How to read code P00AD
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00AD starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (AD) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00AD mean?
Intake air temperature sensor 1 signal high (bank 2). The control unit detected that the signal from the first intake air temperature sensor on bank 2 is above the expected limit. The voltage is too high, as if the air were freezing or as if the circuit were open. It usually points to a detached wire, an open connector or a faulty sensor.
Can I keep driving with code P00AD active?
With caution: limp mode possible, have it checked soon
Common causes — P00AD
Unplugged connector or pins pushed out Broken signal or ground wire Faulty sensor with an open circuit Corrosion in the connector Cut or torn wiring Engine control unit fault (rare)
How do you fix code P00AD?
First check that the bank 2 sensor connector is fully seated and that the wires are intact. It does not normally stop the car at once, but have it checked soon so the engine does not run for long on wrong data.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00AC — Intake air temperature sensor 1 signal low (bank 2...
- Next code: P00AE — Intake air temperature sensor 1 signal intermitten...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2