Skip to content
Fault code dictionary (DTC)

P00AE — Intake air temperature sensor 1 signal intermittent (bank 2)

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the signal from the first intake air temperature sensor on bank 2 drops out or changes from time to time. The value is not always wrong: it shows up now and then. This suggests a poor contact, a wire moving with vibration or a sensor that is starting to fail.
FamilyPowertrain (P)

Typical symptoms

Check engine light on, sometimes going off by itself
Idle that wavers at times
Small hesitations when accelerating
Cold starts not always smooth
Variable fuel consumption

Common causes

Connector with poor contact or corrosion
Chafed wiring that touches at times
Sensor close to failing
Moisture in the connector
Intermittent ground or supply problem
Engine control unit fault (rare)

What to do

First check the connector and gently move the wiring near the bank 2 sensor to see if the fault appears. You can use the car, but an intermittent fault tends to get worse, so do not wait until it becomes permanent.

How to read code P00AE

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00AE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (AE) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00AE mean?

Intake air temperature sensor 1 signal intermittent (bank 2). The control unit detected that the signal from the first intake air temperature sensor on bank 2 drops out or changes from time to time. The value is not always wrong: it shows up now and then. This suggests a poor contact, a wire moving with vibration or a sensor that is starting to fail.

Can I keep driving with code P00AE active?

With caution: limp mode possible, have it checked soon

Common causes — P00AE

Connector with poor contact or corrosion Chafed wiring that touches at times Sensor close to failing Moisture in the connector Intermittent ground or supply problem Engine control unit fault (rare)

How do you fix code P00AE?

First check the connector and gently move the wiring near the bank 2 sensor to see if the fault appears. You can use the car, but an intermittent fault tends to get worse, so do not wait until it becomes permanent.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes