Skip to content
Fault code dictionary (DTC)

P00CB — Fuel volume regulator solenoid supply circuit open

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected an open or broken circuit in the supply to the solenoid that regulates the volume of fuel sent to the pump. Without this supply, the fuel quantity is not managed correctly.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Hard starting
Loss of power
Rough idle
Engine may stall

Common causes

Regulator connector unplugged or corroded
Broken wire in the harness
Faulty supply fuse or relay
Faulty volume regulator solenoid
Control unit problem, less common

What to do

Check the volume regulator connector, fuses and wiring. If the engine stalls or starts badly, avoid using the car and have it checked soon.

How to read code P00CB

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00CB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (CB) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00CB mean?

Fuel volume regulator solenoid supply circuit open. The control unit detected an open or broken circuit in the supply to the solenoid that regulates the volume of fuel sent to the pump. Without this supply, the fuel quantity is not managed correctly.

Can I keep driving with code P00CB active?

With caution: limp mode possible, have it checked soon

Common causes — P00CB

Regulator connector unplugged or corroded Broken wire in the harness Faulty supply fuse or relay Faulty volume regulator solenoid Control unit problem, less common

How do you fix code P00CB?

Check the volume regulator connector, fuses and wiring. If the engine stalls or starts badly, avoid using the car and have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes