P00E6 — Intake air pressure bank 2: sensors disagree
| Meaning | The engine computer compared several intake air pressure sensors on bank 2 and found readings that do not agree. Bank 2 is the side of the engine that does not contain cylinder 1, typical of V or flat engines. One sensor or its circuit is giving a wrong reading, or there is an air leak. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Unstable idle
Uncertain throttle response
Possible limp mode
Common causes
Leak or a disconnected intake or boost hose
Damaged connector or wiring
Blocked or cracked sensor tube
Faulty engine computer (rare)
What to do
How to read code P00E6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00E6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (E6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00E6 mean?
Intake air pressure bank 2: sensors disagree. The engine computer compared several intake air pressure sensors on bank 2 and found readings that do not agree. Bank 2 is the side of the engine that does not contain cylinder 1, typical of V or flat engines. One sensor or its circuit is giving a wrong reading, or there is an air leak.
Can I keep driving with code P00E6 active?
With caution: limp mode possible, have it checked soon
Common causes — P00E6
Faulty or dirty pressure sensor Leak or a disconnected intake or boost hose Damaged connector or wiring Blocked or cracked sensor tube Faulty engine computer (rare)
How do you fix code P00E6?
First check the hoses, clamps and small air tubes on the bank 2 side, then the sensor connectors. With a scan tool, compare the sensor readings with the engine off: they should be similar. If power drops a lot, avoid heavy loads.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00E5 — Intake air and fuel temperature readings do not ag...
- Next code: P00E7 — Intake air temperature bank 2: sensors disagree
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2