P00F4 — Humidity sensor circuit: signal too low
| Meaning | The engine computer read a lower than normal voltage on the circuit of the intake air humidity sensor. This sensor lets the computer adjust engine management for the moisture in the air. With this fault the computer may fall back on default values instead of real readings. |
| Family | Powertrain (P) |
Typical symptoms
Slightly uneven idle in some conditions
Engine responds less sharply than usual
Fuel use or exhaust smoke different from normal
No obvious symptom, just the warning light
Common causes
Sensor wire shorted to ground or with damaged insulation
Faulty humidity sensor
Condensation or moisture inside the sensor
Engine computer fault (rare)
What to do
How to read code P00F4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00F4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (F4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00F4 mean?
Humidity sensor circuit: signal too low. The engine computer read a lower than normal voltage on the circuit of the intake air humidity sensor. This sensor lets the computer adjust engine management for the moisture in the air. With this fault the computer may fall back on default values instead of real readings.
Can I keep driving with code P00F4 active?
With caution: limp mode possible, have it checked soon
Common causes — P00F4
Corroded or loose sensor connector Sensor wire shorted to ground or with damaged insulation Faulty humidity sensor Condensation or moisture inside the sensor Engine computer fault (rare)
How do you fix code P00F4?
First check the connector and wiring of the sensor, which sits in the intake duct. You can drive carefully, but have it diagnosed soon so the fault does not get worse or hide other problems.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00F3 — Humidity sensor out of range or not plausible
- Next code: P00F5 — Humidity sensor circuit: signal too high
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2