P01A0 — Alternative fuel tank A pressure sensor signal too low
| Meaning | The control unit is reading a voltage that is too low from the pressure sensor of alternative fuel tank A, which points to a wire shorted to ground, a break or a faulty sensor. The real pressure may well be normal: it is the signal that is not valid. |
| Family | Powertrain (P) |
Typical symptoms
Gas pressure or level reading at zero or very low
Switching to the main fuel or refusing to use the alternative one
Hard starting on the alternative fuel
Rough running on the alternative fuel
Common causes
Corroded, wet or loose connector
Faulty pressure sensor
Loss of supply to the sensor
Control unit fault, which is rare
What to do
How to read code P01A0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01A0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (A0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01A0 mean?
Alternative fuel tank A pressure sensor signal too low. The control unit is reading a voltage that is too low from the pressure sensor of alternative fuel tank A, which points to a wire shorted to ground, a break or a faulty sensor. The real pressure may well be normal: it is the signal that is not valid.
Can I keep driving with code P01A0 active?
With caution: limp mode possible, have it checked soon
Common causes — P01A0
Sensor wire shorted to ground Corroded, wet or loose connector Faulty pressure sensor Loss of supply to the sensor Control unit fault, which is rare
How do you fix code P01A0?
Check the sensor connector and wiring for moisture, corrosion or damaged insulation. Work on the gas system should be left to a qualified technician. You can use the main fuel in the meantime, but have the fault checked within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P019F — Alternative fuel tank A pressure sensor performanc...
- Next code: P01A1 — Alternative fuel tank A pressure sensor signal too...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible