P01A1 — Alternative fuel tank A pressure sensor signal too high
| Meaning | The control unit is reading a voltage that is too high from the pressure sensor of alternative fuel tank A, which points to a wire shorted to supply, an open circuit or a faulty sensor. The real pressure is not necessarily high: it is the signal that is not believable. |
| Family | Powertrain (P) |
Typical symptoms
Gas pressure reading very high or off the scale
Switching to the main fuel or refusing to use the alternative one
Hard starting on the alternative fuel
Rough running on the alternative fuel
Common causes
Corroded, wet or loose connector
Faulty pressure sensor
Broken ground connection at the sensor
Control unit fault, which is rare
What to do
How to read code P01A1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01A1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (A1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01A1 mean?
Alternative fuel tank A pressure sensor signal too high. The control unit is reading a voltage that is too high from the pressure sensor of alternative fuel tank A, which points to a wire shorted to supply, an open circuit or a faulty sensor. The real pressure is not necessarily high: it is the signal that is not believable.
Can I keep driving with code P01A1 active?
With caution: limp mode possible, have it checked soon
Common causes — P01A1
Sensor wire shorted to supply voltage Corroded, wet or loose connector Faulty pressure sensor Broken ground connection at the sensor Control unit fault, which is rare
How do you fix code P01A1?
Check the sensor connector, wiring and ground. If you suspect the tank pressure is truly high, do not tamper with anything and have the system checked immediately by a qualified technician. If there are no other signs of danger, use the main fuel and have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01A0 — Alternative fuel tank A pressure sensor signal too...
- Next code: P01A2 — Alternative fuel tank A pressure sensor signal err...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible