P01A2 — Alternative fuel tank A pressure sensor signal erratic
| Meaning | The control unit is receiving a signal from the pressure sensor of alternative fuel tank A that jumps or is irregular, in a way that does not fit a real pressure change. The problem comes and goes, so it may not show up during testing. |
| Family | Powertrain (P) |
Typical symptoms
Gas pressure or level reading that fluctuates
Sudden switches to the main fuel
Rough running on the alternative fuel
Occasional uncertain starting
Common causes
Wiring with a nearly broken conductor or one that is rubbing
Pressure sensor on its way out
Unstable sensor ground or supply
Control unit fault, which is rare
What to do
How to read code P01A2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01A2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (A2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01A2 mean?
Alternative fuel tank A pressure sensor signal erratic. The control unit is receiving a signal from the pressure sensor of alternative fuel tank A that jumps or is irregular, in a way that does not fit a real pressure change. The problem comes and goes, so it may not show up during testing.
Can I keep driving with code P01A2 active?
With caution: limp mode possible, have it checked soon
Common causes — P01A2
Loose or corroded connector Wiring with a nearly broken conductor or one that is rubbing Pressure sensor on its way out Unstable sensor ground or supply Control unit fault, which is rare
How do you fix code P01A2?
Check the sensor connector and wiring, gently moving them with the vehicle off to find a poor contact. Work on the gas system belongs to a qualified technician. An intermittent fault tends to get worse, so do not put it off for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01A1 — Alternative fuel tank A pressure sensor signal too...
- Next code: P01A3 — Alternative fuel rail pressure sensor circuit faul...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible