P01B6 — Alt. fuel rail temperature sensor: signal too low
| Meaning | The control unit found that the signal from the alternative fuel rail temperature sensor is below the normal range. This usually points to a short to ground in the wiring or a failed sensor. The gas temperature is read as extremely high or invalid. |
| Family | Powertrain (P) |
Typical symptoms
Uneven running on gas
Forced switch to petrol or diesel
Loss of power on gas
Hard starting on gas
Common causes
Failed temperature sensor
Connector with water or corrosion
Control unit fault (rare)
What to do
How to read code P01B6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01B6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (B6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01B6 mean?
Alt. fuel rail temperature sensor: signal too low. The control unit found that the signal from the alternative fuel rail temperature sensor is below the normal range. This usually points to a short to ground in the wiring or a failed sensor. The gas temperature is read as extremely high or invalid.
Can I keep driving with code P01B6 active?
With caution: limp mode possible, have it checked soon
Common causes — P01B6
Pinched or burnt wiring touching ground Failed temperature sensor Connector with water or corrosion Control unit fault (rare)
How do you fix code P01B6?
Inspect the wiring and connector of the sensor on the rail, especially where it passes near hot parts or sharp edges. Use normal fuel until the gas system has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01B5 — Alt. fuel rail temperature sensor: implausible rea...
- Next code: P01B7 — Alt. fuel rail temperature sensor: signal too high
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible