Skip to content
Fault code dictionary (DTC)

P01E0 — Cylinder 11 injection timing too advanced

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that fuel injection in cylinder 11 happens before the commanded moment. Combustion starts too early and the cylinder does not work as it should. The code describes the fault; it does not point to the part to replace.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Knocking or metallic noise from the engine
Rough idle
Loss of power
Smell of unburnt fuel
Difficult starting

Common causes

Cylinder 11 injector worn or responding abnormally
Electrical fault in the injector wiring or connector
Irregular fuel pressure
Wrong signal from the crankshaft or camshaft sensors
Engine timing out of position
Internal control unit fault, which is rare

What to do

Have the live data of the cylinder 11 injector checked, plus the wiring and the fuel pressure, and compare the engine speed sensor signals. If you hear the engine knocking, avoid hard acceleration and have it looked at soon.

How to read code P01E0

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P01E0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (E0) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01E0 mean?

Cylinder 11 injection timing too advanced. The control unit detected that fuel injection in cylinder 11 happens before the commanded moment. Combustion starts too early and the cylinder does not work as it should. The code describes the fault; it does not point to the part to replace.

Can I keep driving with code P01E0 active?

With caution: limp mode possible, have it checked soon

Common causes — P01E0

Cylinder 11 injector worn or responding abnormally Electrical fault in the injector wiring or connector Irregular fuel pressure Wrong signal from the crankshaft or camshaft sensors Engine timing out of position Internal control unit fault, which is rare

How do you fix code P01E0?

Have the live data of the cylinder 11 injector checked, plus the wiring and the fuel pressure, and compare the engine speed sensor signals. If you hear the engine knocking, avoid hard acceleration and have it looked at soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes