P01E1 — Cylinder 12 injection timing too retarded
| Meaning | The control unit detected that fuel injection in cylinder 12 happens later than the commanded moment. Fuel enters when combustion should already have started and the cylinder performs worse. The code reports the delay but does not by itself identify the part at fault. |
| Family | Powertrain (P) |
Typical symptoms
Rough engine operation
Lack of power under load
Hesitation when accelerating
Dark smoke or fuel smell from the exhaust
Vibration at idle
Common causes
Damaged injector wiring or connector
Low or unstable fuel pressure
Wrong signal from the crankshaft or camshaft sensors
Engine timing out of position
Internal control unit fault, which is rare
What to do
How to read code P01E1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01E1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (E1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01E1 mean?
Cylinder 12 injection timing too retarded. The control unit detected that fuel injection in cylinder 12 happens later than the commanded moment. Fuel enters when combustion should already have started and the cylinder performs worse. The code reports the delay but does not by itself identify the part at fault.
Can I keep driving with code P01E1 active?
With caution: limp mode possible, have it checked soon
Common causes — P01E1
Cylinder 12 injector slow, dirty or worn Damaged injector wiring or connector Low or unstable fuel pressure Wrong signal from the crankshaft or camshaft sensors Engine timing out of position Internal control unit fault, which is rare
How do you fix code P01E1?
First check the wiring and connector of the cylinder 12 injector, then the fuel pressure and live data. Avoid replacing the injector without testing it. It is best to have the car inspected soon and to avoid heavy engine loads.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01E0 — Cylinder 11 injection timing too advanced
- Next code: P01E2 — Cylinder 12 injection timing too advanced
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible