P01E3 — Coolant temperature sensor 3 circuit fault
| Meaning | The control unit detected a fault in the electrical circuit of the third engine coolant temperature sensor. The signal it receives is not what it expects. Which point of the engine this third sensor monitors depends on the manufacturer, and I have no reliable information to say without knowing the make and model. |
| Family | Powertrain (P) |
Typical symptoms
Cooling fan running all the time or at unusual moments
Abnormal temperature gauge reading on the dashboard
Harder cold starting
Fuel consumption that seems higher
Rough running when the engine is cold
Common causes
Corroded connector or poor contact
Faulty temperature sensor
Coolant level or quality not correct
Ground or supply problem at the sensor
Internal control unit fault, which is rare
What to do
How to read code P01E3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01E3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (E3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01E3 mean?
Coolant temperature sensor 3 circuit fault. The control unit detected a fault in the electrical circuit of the third engine coolant temperature sensor. The signal it receives is not what it expects. Which point of the engine this third sensor monitors depends on the manufacturer, and I have no reliable information to say without knowing the make and model.
Can I keep driving with code P01E3 active?
With caution: limp mode possible, have it checked soon
Common causes — P01E3
Sensor wiring damaged, disconnected or shorted Corroded connector or poor contact Faulty temperature sensor Coolant level or quality not correct Ground or supply problem at the sensor Internal control unit fault, which is rare
How do you fix code P01E3?
First check the sensor connector and wiring, and the coolant level with the engine cold. Then have the value read by the sensor compared with the real temperature. You can drive with care, but watch the temperature gauge often and stop if it rises abnormally.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01E2 — Cylinder 12 injection timing too advanced
- Next code: P01E4 — Coolant temperature sensor 3 signal implausible
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible