Skip to content
Fault code dictionary (DTC)

P01E4 — Coolant temperature sensor 3 signal implausible

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the signal from the third engine coolant temperature sensor is outside the expected range or does not agree with the other engine temperatures. The electrical circuit may be intact, but the value is not believable. Which point of the engine this sensor monitors depends on the manufacturer, and I have no reliable information to say without the make and model.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Temperature gauge that does not follow the real trend
Fan starting too early or too late
Difficult cold starting
Engine that never seems to reach operating temperature
Rough running when the engine is cold

Common causes

Aged or inaccurate temperature sensor
Low coolant level or air in the cooling circuit
Thermostat not opening or closing properly
Poor contact in the connector or abnormal resistance in the wiring
Sensor fitted where the coolant does not circulate well
Internal control unit fault, which is rare

What to do

Have the coolant level checked and the sensor value compared with the other temperature sensors, cold and warm. Check the thermostat too. It is not an immediate emergency, but if the gauge climbs too high, stop and switch the engine off.

How to read code P01E4

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P01E4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (E4) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01E4 mean?

Coolant temperature sensor 3 signal implausible. The control unit detected that the signal from the third engine coolant temperature sensor is outside the expected range or does not agree with the other engine temperatures. The electrical circuit may be intact, but the value is not believable. Which point of the engine this sensor monitors depends on the manufacturer, and I have no reliable information to say without the make and model.

Can I keep driving with code P01E4 active?

With caution: limp mode possible, have it checked soon

Common causes — P01E4

Aged or inaccurate temperature sensor Low coolant level or air in the cooling circuit Thermostat not opening or closing properly Poor contact in the connector or abnormal resistance in the wiring Sensor fitted where the coolant does not circulate well Internal control unit fault, which is rare

How do you fix code P01E4?

Have the coolant level checked and the sensor value compared with the other temperature sensors, cold and warm. Check the thermostat too. It is not an immediate emergency, but if the gauge climbs too high, stop and switch the engine off.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes