P01E5 — Coolant temperature sensor 3 circuit low
| Meaning | The control unit detected that the voltage from the third engine coolant temperature sensor is too low. This is normally read as a very high temperature, even if the engine is not actually that hot. Which point of the engine this sensor monitors depends on the manufacturer, and I have no reliable information to say without the make and model. |
| Family | Powertrain (P) |
Typical symptoms
Cooling fan running all the time
Temperature gauge reading very high for no reason
Rough running when the engine is cold
Difficult cold starting
Fuel consumption that seems higher
Common causes
Faulty temperature sensor
Wet, dirty or damaged connector
Crushed wiring or damaged insulation
Internal control unit fault, which is rare
What to do
How to read code P01E5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01E5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (E5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01E5 mean?
Coolant temperature sensor 3 circuit low. The control unit detected that the voltage from the third engine coolant temperature sensor is too low. This is normally read as a very high temperature, even if the engine is not actually that hot. Which point of the engine this sensor monitors depends on the manufacturer, and I have no reliable information to say without the make and model.
Can I keep driving with code P01E5 active?
With caution: limp mode possible, have it checked soon
Common causes — P01E5
Sensor wire shorted to ground Faulty temperature sensor Wet, dirty or damaged connector Crushed wiring or damaged insulation Internal control unit fault, which is rare
How do you fix code P01E5?
Check the sensor wiring and connector, looking for crushed wires or moisture. Then have the value it reads compared with the real engine temperature. If the gauge shows hot but the engine is not really hot, you can carry on with care; if the engine is genuinely overheating, stop at once.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01E4 — Coolant temperature sensor 3 signal implausible
- Next code: P01E6 — Coolant temperature sensor 3 circuit high
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible