P01F3 — O2 sensor circuit high voltage, bank 1 sensor 4
| Meaning | The control unit reads a higher voltage than normal from the oxygen sensor labelled sensor 4 on bank 1. It can come from the sensor, from a wire touching a power supply, or from a very rich mixture. Which sensor is sensor 4 must be verified on your car's diagram. |
| Family | Powertrain (P) |
Typical symptoms
Fuel smell or dark smoke from the exhaust
Higher fuel use
Rough running
Possible emissions test failure
Common causes
Signal wire touching a power supply
Damaged connector
Overly rich mixture from other faults
Wiring fault near the exhaust
What to do
How to read code P01F3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01F3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (F3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01F3 mean?
O2 sensor circuit high voltage, bank 1 sensor 4. The control unit reads a higher voltage than normal from the oxygen sensor labelled sensor 4 on bank 1. It can come from the sensor, from a wire touching a power supply, or from a very rich mixture. Which sensor is sensor 4 must be verified on your car's diagram.
Can I keep driving with code P01F3 active?
With caution: limp mode possible, have it checked soon
Common causes — P01F3
Failed or contaminated oxygen sensor Signal wire touching a power supply Damaged connector Overly rich mixture from other faults Wiring fault near the exhaust
How do you fix code P01F3?
Check the sensor connector and wiring and make sure there are no other mixture codes. If you notice a fuel smell or dark smoke, have the car checked soon, because a rich mixture over time damages the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01F2 — O2 sensor circuit low voltage, bank 1 sensor 4
- Next code: P01F4 — O2 sensor slow response, bank 1 sensor 4
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible