P01F4 — O2 sensor slow response, bank 1 sensor 4
| Meaning | The control unit found that the oxygen sensor labelled sensor 4 on bank 1 reacts too slowly to mixture changes. A healthy sensor changes its signal quickly. Which sensor is sensor 4 depends on the car and must be verified on the diagram. |
| Family | Powertrain (P) |
Typical symptoms
No obvious change in driving
Slightly higher fuel use
Possible emissions test failure
Idle sometimes irregular
Common causes
Contamination from oil, coolant or additives
Exhaust leak near the sensor
Sensor heater not working well
Wiring or connector with a poor contact
What to do
How to read code P01F4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01F4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (F4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01F4 mean?
O2 sensor slow response, bank 1 sensor 4. The control unit found that the oxygen sensor labelled sensor 4 on bank 1 reacts too slowly to mixture changes. A healthy sensor changes its signal quickly. Which sensor is sensor 4 depends on the car and must be verified on the diagram.
Can I keep driving with code P01F4 active?
With caution: limp mode possible, have it checked soon
Common causes — P01F4
Aged or dirty oxygen sensor Contamination from oil, coolant or additives Exhaust leak near the sensor Sensor heater not working well Wiring or connector with a poor contact
How do you fix code P01F4?
Have the sensor's live data read and check that the exhaust is not leaking. It is not urgent, but a slow sensor makes mixture control work poorly, so it is worth dealing with.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01F3 — O2 sensor circuit high voltage, bank 1 sensor 4
- Next code: P01F5 — O2 sensor no activity detected, bank 1 sensor 4
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible