Skip to content
Fault code dictionary (DTC)

P01F5 — O2 sensor no activity detected, bank 1 sensor 4

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit sees no change in signal from the oxygen sensor labelled sensor 4 on bank 1: the signal stays flat. It often means a dead sensor or an open circuit. Which sensor is sensor 4 must be verified on your car's diagram.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
No obvious change in driving
Slightly higher fuel use
Possible emissions test failure
Other codes on the sensor

Common causes

Failed oxygen sensor
Disconnected or corroded connector
Broken signal wire
Missing fuse or power for the sensor heater
Internal control unit fault (uncommon)

What to do

Check the connector, wiring and heater fuse of the sensor, then have the live data checked. The car can usually be used, but have it looked at soon.

How to read code P01F5

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P01F5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (F5) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01F5 mean?

O2 sensor no activity detected, bank 1 sensor 4. The control unit sees no change in signal from the oxygen sensor labelled sensor 4 on bank 1: the signal stays flat. It often means a dead sensor or an open circuit. Which sensor is sensor 4 must be verified on your car's diagram.

Can I keep driving with code P01F5 active?

With caution: limp mode possible, have it checked soon

Common causes — P01F5

Failed oxygen sensor Disconnected or corroded connector Broken signal wire Missing fuse or power for the sensor heater Internal control unit fault (uncommon)

How do you fix code P01F5?

Check the connector, wiring and heater fuse of the sensor, then have the live data checked. The car can usually be used, but have it looked at soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes