P041C — EGR temperature sensor B: signal too low
| Meaning | The engine computer is receiving too low a voltage from EGR temperature sensor B, lower than the sensor can give in normal use. This usually points to a short to ground in the wiring or a failed sensor. Which sensor is B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Uneven idle or reduced performance
EGR operation switched off by the computer
Black smoke on diesel cars
Other EGR codes stored
Common causes
Failed EGR temperature sensor B
Connector with water or corrosion
Wiring pinched or rubbed through
Engine computer (rare)
What to do
How to read code P041C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P041C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (1C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P041C mean?
EGR temperature sensor B: signal too low. The engine computer is receiving too low a voltage from EGR temperature sensor B, lower than the sensor can give in normal use. This usually points to a short to ground in the wiring or a failed sensor. Which sensor is B depends on the manufacturer.
Can I keep driving with code P041C active?
With caution: limp mode possible, have it checked soon
Common causes — P041C
Sensor wire touching ground Failed EGR temperature sensor B Connector with water or corrosion Wiring pinched or rubbed through Engine computer (rare)
How do you fix code P041C?
Inspect the wiring and connector of sensor B for rubbing or moisture, then check the sensor. You can keep driving, but have the circuit checked within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P041B — EGR temperature sensor B: reading out of expected...
- Next code: P041D — EGR temperature sensor B: signal too high
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance