Skip to content
Fault code dictionary (DTC)

P041D — EGR temperature sensor B: signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer is receiving too high a voltage from EGR temperature sensor B, higher than the sensor can give in normal use. This usually points to a broken wire, an unplugged connector or a failed sensor. Which sensor is B depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Uneven idle or reduced performance
EGR operation switched off by the computer
Black smoke on diesel cars
Other EGR codes stored

Common causes

Sensor connector unplugged or corroded
Broken sensor wire
Failed EGR temperature sensor B
Wiring touching the supply voltage
Engine computer (rare)

What to do

First check that the connector of sensor B is plugged in and clean, then check the wiring for continuity and the sensor itself. You can keep driving, but have it checked within a reasonable time.

How to read code P041D

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P041D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (1D) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P041D mean?

EGR temperature sensor B: signal too high. The engine computer is receiving too high a voltage from EGR temperature sensor B, higher than the sensor can give in normal use. This usually points to a broken wire, an unplugged connector or a failed sensor. Which sensor is B depends on the manufacturer.

Can I keep driving with code P041D active?

With caution: limp mode possible, have it checked soon

Common causes — P041D

Sensor connector unplugged or corroded Broken sensor wire Failed EGR temperature sensor B Wiring touching the supply voltage Engine computer (rare)

How do you fix code P041D?

First check that the connector of sensor B is plugged in and clean, then check the wiring for continuity and the sensor itself. You can keep driving, but have it checked within a reasonable time.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes