P041E — EGR temperature sensor B: erratic or intermittent signal
| Meaning | The engine computer has detected that the signal from EGR temperature sensor B drops out or jumps around from time to time. A contact that comes and goes is the most common explanation. If the signal can't be trusted, the computer can't properly verify that the EGR works. Which sensor is B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Uneven idle at times
Loss of power in some conditions
Black smoke on diesel cars
Fault appears with vibration or damp
Common causes
Wiring chafed or with a wire that breaks contact now and then
Internal failure of EGR temperature sensor B
Soot on the sensor
Engine computer (rare)
What to do
How to read code P041E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P041E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (1E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P041E mean?
EGR temperature sensor B: erratic or intermittent signal. The engine computer has detected that the signal from EGR temperature sensor B drops out or jumps around from time to time. A contact that comes and goes is the most common explanation. If the signal can't be trusted, the computer can't properly verify that the EGR works. Which sensor is B depends on the manufacturer.
Can I keep driving with code P041E active?
With caution: limp mode possible, have it checked soon
Common causes — P041E
Corroded, loose or poorly seated connector Wiring chafed or with a wire that breaks contact now and then Internal failure of EGR temperature sensor B Soot on the sensor Engine computer (rare)
How do you fix code P041E?
Check the connector and wiring of sensor B, moving them gently with the engine running to see whether the fault appears. You can drive short distances, but don't put it off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P041D — EGR temperature sensor B: signal too high
- Next code: P041F — Secondary air switching valve A: circuit low
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance