P043E — EVAP leak detection reference orifice, low flow
| Meaning | The EVAP system captures fuel vapour from the tank so it does not escape into the air. On cars with a leak detection pump, the control unit checks a small calibrated reference hole and found less flow than expected. This means the leak test cannot be trusted, not necessarily that there is a leak. |
| Family | Powertrain (P) |
Typical symptoms
Usually no change in driving
Possible faint fuel smell near the tank
Possible failure at the emissions inspection
Common causes
Faulty leak detection pump
Clogged or pinched EVAP valve or hoses
Poor pump connector or wiring
Control unit fault, which is rare
What to do
How to read code P043E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P043E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (3E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P043E mean?
EVAP leak detection reference orifice, low flow. The EVAP system captures fuel vapour from the tank so it does not escape into the air. On cars with a leak detection pump, the control unit checks a small calibrated reference hole and found less flow than expected. This means the leak test cannot be trusted, not necessarily that there is a leak.
Can I keep driving with code P043E active?
With caution: limp mode possible, have it checked soon
Common causes — P043E
Leak detection pump air filter or duct blocked by dirt or insects Faulty leak detection pump Clogged or pinched EVAP valve or hoses Poor pump connector or wiring Control unit fault, which is rare
How do you fix code P043E?
Have the leak detection pump and its connected vent lines checked for blockages. There is no immediate risk to driving, but the fault leaves the system unmonitored, so do not put it off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P043D — Catalyst temperature sensor signal high, bank 2 se...
- Next code: P043F — EVAP leak detection reference orifice, high flow
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance