P043F — EVAP leak detection reference orifice, high flow
| Meaning | During the EVAP leak detection pump test, the control unit checks a small calibrated reference hole. It found more flow than expected, so the leak test cannot give reliable results. Often there is a leak or a part that is not sealing in the system. |
| Family | Powertrain (P) |
Typical symptoms
Usually no change in driving
Possible fuel smell near the tank or wheel arch
Possible failure at the emissions inspection
Common causes
Faulty leak detection pump
Faulty or badly fitted fuel cap
Cracked charcoal canister
Control unit fault, which is rare
What to do
How to read code P043F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P043F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (3F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P043F mean?
EVAP leak detection reference orifice, high flow. During the EVAP leak detection pump test, the control unit checks a small calibrated reference hole. It found more flow than expected, so the leak test cannot give reliable results. Often there is a leak or a part that is not sealing in the system.
Can I keep driving with code P043F active?
With caution: limp mode possible, have it checked soon
Common causes — P043F
EVAP hose, fitting or seal not sealing Faulty leak detection pump Faulty or badly fitted fuel cap Cracked charcoal canister Control unit fault, which is rare
How do you fix code P043F?
First check that the fuel cap is tight and in good condition, then have the EVAP hoses and fittings checked. It will not stop the car, but if you smell fuel have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P043E — EVAP leak detection reference orifice, low flow
- Next code: P0440 — Evaporative emission control system malfunction
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance