Skip to content
Fault code dictionary (DTC)

P0440 — Evaporative emission control system malfunction

Severity: Informational Can you drive? Yes, no known limitation Make: All makes (OBD-II standard)
MeaningThe control unit detected a general fault in the EVAP system, which collects fuel vapour and sends it to the engine to be burned. The code says something is wrong but not what. Often the cause is a small leak or a part that does not open or close as it should.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Usually no change in driving
Fuel smell in some cases
Difficult refuelling, with the pump nozzle clicking off repeatedly
Possible failure at the emissions inspection

Common causes

Worn, missing or badly closed fuel cap
Cracked or disconnected EVAP hoses
Faulty purge or vent valve
Damaged charcoal canister
Faulty tank pressure sensor

What to do

Start with the fuel cap: check that it is intact and tightly closed. If the light stays on, have a leak test of the system done. You can drive the car, but do not leave the fault unresolved for long.

How to read code P0440

This is an informational entry: it normally does not limit how the vehicle works.

The code P0440 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (40) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0440 mean?

Evaporative emission control system malfunction. The control unit detected a general fault in the EVAP system, which collects fuel vapour and sends it to the engine to be burned. The code says something is wrong but not what. Often the cause is a small leak or a part that does not open or close as it should.

Can I keep driving with code P0440 active?

Yes, no known limitation

Common causes — P0440

Worn, missing or badly closed fuel cap Cracked or disconnected EVAP hoses Faulty purge or vent valve Damaged charcoal canister Faulty tank pressure sensor

How do you fix code P0440?

Start with the fuel cap: check that it is intact and tightly closed. If the light stays on, have a leak test of the system done. You can drive the car, but do not leave the fault unresolved for long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes