P044B — EGR sensor "C" signal out of range
| Meaning | The control unit receives a value from EGR sensor "C" that does not match what is expected for the driving conditions. The signal arrives, but it is not consistent with how the system is working. Which sensor is "C" depends on the manufacturer, so I cannot say for certain without knowing the make. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Reduced performance
Exhaust smoke in some cases
Possible failure at the emissions inspection
Common causes
Dirty or stuck EGR valve
EGR passages clogged with soot
Leaks in the intake or exhaust
Wiring with abnormal resistance
What to do
How to read code P044B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P044B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (4B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P044B mean?
EGR sensor "C" signal out of range. The control unit receives a value from EGR sensor "C" that does not match what is expected for the driving conditions. The signal arrives, but it is not consistent with how the system is working. Which sensor is "C" depends on the manufacturer, so I cannot say for certain without knowing the make.
Can I keep driving with code P044B active?
With caution: limp mode possible, have it checked soon
Common causes — P044B
Drifting or aged EGR sensor Dirty or stuck EGR valve EGR passages clogged with soot Leaks in the intake or exhaust Wiring with abnormal resistance
How do you fix code P044B?
Have the EGR valve and passages checked, since they often get dirty, and then the sensor. If you notice a loss of power, do not put it off for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usRelated codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance