P044C — EGR sensor "C" signal low
| Meaning | The control unit reads a voltage from EGR sensor "C" that is lower than allowed. This usually points to a wire shorted to ground, a missing power supply or a faulty sensor. The type of sensor "C" is set by the manufacturer, so I cannot say for certain which one it is without knowing the make. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Loss of power
Possible limp mode
Possible failure at the emissions inspection
Common causes
Sensor power supply missing or interrupted
Corroded or loose connector
Faulty EGR sensor
Control unit fault, which is rare
What to do
How to read code P044C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P044C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (4C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P044C mean?
EGR sensor "C" signal low. The control unit reads a voltage from EGR sensor "C" that is lower than allowed. This usually points to a wire shorted to ground, a missing power supply or a faulty sensor. The type of sensor "C" is set by the manufacturer, so I cannot say for certain which one it is without knowing the make.
Can I keep driving with code P044C active?
With caution: limp mode possible, have it checked soon
Common causes — P044C
Sensor wire shorted to ground Sensor power supply missing or interrupted Corroded or loose connector Faulty EGR sensor Control unit fault, which is rare
How do you fix code P044C?
Check the sensor connector and wiring, looking for crushed or corroded cables. If power drops or the engine goes into limp mode, have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P044B — EGR sensor "C" signal out of range
- Next code: P044D — EGR sensor "C" signal high
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance