P044E — EGR sensor "C" signal intermittent or erratic
| Meaning | The control unit sees a signal from EGR sensor "C" that comes and goes or swings abnormally. This suggests a poor contact more than a steady failure. Which sensor is "C" depends on the manufacturer, so I cannot say for certain without knowing the make. |
| Family | Powertrain (P) |
Typical symptoms
Idle that rises and falls
Hesitation or jerking at times
Occasional loss of power
The problem shows up with vibration or after engine washing
Common causes
Wiring with a partly broken or chafed wire
EGR sensor working intermittently
Vibration or moisture affecting the contacts
EGR valve that sticks at times
What to do
How to read code P044E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P044E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (4E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P044E mean?
EGR sensor "C" signal intermittent or erratic. The control unit sees a signal from EGR sensor "C" that comes and goes or swings abnormally. This suggests a poor contact more than a steady failure. Which sensor is "C" depends on the manufacturer, so I cannot say for certain without knowing the make.
Can I keep driving with code P044E active?
With caution: limp mode possible, have it checked soon
Common causes — P044E
Loose or corroded connector Wiring with a partly broken or chafed wire EGR sensor working intermittently Vibration or moisture affecting the contacts EGR valve that sticks at times
How do you fix code P044E?
With the engine off, gently move the connector and wiring to look for loose contacts, and check for chafed cables. An intermittent fault tends to get worse, so it is worth having it looked at soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P044D — EGR sensor "C" signal high
- Next code: P044F — AIR system switching valve A circuit high
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance