Skip to content
Fault code dictionary (DTC)

P044F — AIR system switching valve A circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected too high a voltage in the circuit of switching valve "A" of the AIR system, which pumps fresh air into the exhaust after a cold start to burn off leftover hydrocarbons. It usually means an open circuit or a short to a power supply. On some makes the meaning of "A" can differ.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Higher emissions after a cold start
Possible failure at the emissions inspection
Usually no noticeable change in driving

Common causes

Damaged valve connector or wiring
Wire shorted to a power supply or broken
Faulty air switching valve
Fuse or relay of the secondary air system
Control unit fault, which is rare

What to do

Check the connector, wiring, fuse and relay of the secondary air system, as well as the condition of the valve. It will not stop the car, but the system is not working as intended when cold, so do not put it off for long.

How to read code P044F

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P044F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (4F) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P044F mean?

AIR system switching valve A circuit high. The control unit detected too high a voltage in the circuit of switching valve "A" of the AIR system, which pumps fresh air into the exhaust after a cold start to burn off leftover hydrocarbons. It usually means an open circuit or a short to a power supply. On some makes the meaning of "A" can differ.

Can I keep driving with code P044F active?

With caution: limp mode possible, have it checked soon

Common causes — P044F

Damaged valve connector or wiring Wire shorted to a power supply or broken Faulty air switching valve Fuse or relay of the secondary air system Control unit fault, which is rare

How do you fix code P044F?

Check the connector, wiring, fuse and relay of the secondary air system, as well as the condition of the valve. It will not stop the car, but the system is not working as intended when cold, so do not put it off for long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes