Skip to content
Fault code dictionary (DTC)

P04AD — EVAP purge valve B circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit is seeing too high a voltage on the control circuit of EVAP purge valve B. This usually points to a wire touching the power supply, or a problem with the valve's ground connection or control. The valve may therefore not respond correctly.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough idle or engine tending to stall
Hard starting after refueling
Fuel smell
Failed emissions inspection

Common causes

Control wire touching the power supply
Broken ground connection at the valve
Faulty purge valve
Connector with damaged terminals
Faulty engine control unit, which is rare

What to do

First check the valve connector and wiring, especially the ground wire. Have it looked at soon, because the valve could be stuck open or closed out of control.

How to read code P04AD

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P04AD starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (AD) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P04AD mean?

EVAP purge valve B circuit high. The control unit is seeing too high a voltage on the control circuit of EVAP purge valve B. This usually points to a wire touching the power supply, or a problem with the valve's ground connection or control. The valve may therefore not respond correctly.

Can I keep driving with code P04AD active?

With caution: limp mode possible, have it checked soon

Common causes — P04AD

Control wire touching the power supply Broken ground connection at the valve Faulty purge valve Connector with damaged terminals Faulty engine control unit, which is rare

How do you fix code P04AD?

First check the valve connector and wiring, especially the ground wire. Have it looked at soon, because the valve could be stuck open or closed out of control.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes